Command: under

Syntax

under { <window> }

Description

Display an orthographic plan view of the model seen from below.

Parameters

• <window>
  A window identifier. The window must be a graphic window. If omitted, the current graphic window is used.

Switches

• -loc
  Display an under view of the window’s local axes, rather than using the global axes (the default).

• -o1=<num>
  A Z ordinate defining the front (hither) viewing plane. If omitted, the bottom side of the window’s orthogonal box is used.

• -o2=<num>
  A Z ordinate defining the rear (yon) viewing plane. If omitted, the top side of the window’s orthogonal box is used.

• -p1=<point>
  A 3-D point defining the front (hither) viewing plane. If omitted, the bottom side of the window’s orthogonal box is used.

• -p2=<point>
  A 3-D point defining the rear (yon) viewing plane. If omitted, the top side of the window’s orthogonal box is used.

Notes

If the window is not currently in use, or is not a graphic window, no action is taken.

Examples

Draw an underside view of the current orthogonal box in the current graphic window.

under

Draw an underside view of the current orthogonal box in a specified window.

under win2

Draw an underside view between two points.

under -p1=p0, -p2=my_point

Draw an underside view between two Z ordinates.

under -o1=10, -o2=100

See Also